Sangfor HCI and aSV provide a unified infrastructure combining compute, storage, networking, and built-in security to simplify deployment, operations, and services.
The aServer has pre-installed the HCI operating system and set the eth0 interface as the management interface. The default IP address is 10.250.0.7/24. Use a PC to configure the IP address of the same network segment, connect directly to the eth0 port, and open it with a browser https://10.250.0.7/. Then, you can log in to the console of the aServer.
The default administrator account and password are admin. You will be prompted to change the default password when you log in for the first time. You will be forced to change the default password after a month.
After the first successful login, you will be prompted to modify the default IP address. If there are multiple aServer nodes, you need to log in separately to modify the default IP address before forming a cluster, and the IP address must be in the same network segment.
The aServer is signed and can only use the signed disk (shipped from the original factory). If the aServer is inserted into a third-party disk, it cannot be recognized in virtual storage and can only be used for local storage.
When virtual storage is used, node deletion is not supported. Taking the node out for separate use is forbidden after the cluster is disassembled.
The aServer cannot reinstall the system. After reinstalling the system, you need to re-sign the node and disk.
Do not perform a low-level format on the aServer disk. Re-sign is required after formatting.
Please refer to theBIOS Configuration Requirement section below for the configuration of the IPMI interface.
{{ $t('index.defaultHeader.chromeBrowserTip') }}