Virtual IP Pool supports the creation of a virtual IP address pool for branch users. The interface is shown as follows:

In the IP pool of the branch user, the virtual IP segment for the branch's access to the headquarters replaces the original segment at the branch to a segment in the virtual IP pool, solving the LAN IP conflicts when two branches for the same segment access the headquarters. Click New, select Branch user for type, set the Start IP and End IP for virtual IP addresses (Click Get to calculate the applicable End IP automatically), netmask, and a number of branch segments. See the picture below:

Start IP: The first IP address of the branch virtual IP segment.

End IP: The last IP address of the branch virtual IP segment.

Get: Automatically calculate the last IP address of the virtual IP segment.

Number of Segments: The number of virtual IP segments needed.

Subnet mask: The subnet mask of the virtual IP segment. It shall be consistent with the subnet mask at the branch.

After setting the branch virtual IP segment, create a new user in VPN Information Settings/User Management, select Branch for user type, and then configure the branch segments to be switched in Advance/NAT Settings in Tunnels.