After finishing all the wiring, you can log into the Web User Interface (UI) to configure the Sangfor IAG device. Follow the procedures below to log into the console of the IAG device:

Step 1.Configure an IP address (for example, 10.251.251.100) on the 10.251.251.X subnet for the computer, and then type the default login IP address and port in the IE address bar: https://10.251.251.251. Click Go, and the following alert dialog appears:

Step 2.Click Yes to go to the login page, as shown in the following figure.

Step 3.Type the username and password, read the Terms of Use and Privacy Policy, select I have read and agree to the Terms of Use and Privacy Policy, and click Login to log into the IAG device console. The username and password are admin by default. (If you have any questions about the Terms of Use and Privacy Policy, please contact us).

If the user's password is too simple, it will be detected to be weak. On the console, the system prompts to modify the weak password after login. The popup is shown below:

If the password is not modified within 15 days, a compulsory password modification will prompt on the next login.

To view the version of the current IAG gateway device, click Version.

You can log into the console without installing any ActiveX. Non-IE browsers are also supported.